JKS Manufacturing Control Arm Relocation Bracket - JKS6200

JKS Manufacturing Control Arm Relocation Bracket

Control Arm Relocation Bracket; Jspec; Used To Relocate The Upper And Lower Control Arms; With 2 To 4-1/2 Inch Lift

MPN: 6200

Features

• Reduced Control Arm Angles Allow The Front Suspension To More Naturally Roll Over Bumps And Grooves In The Road
• Corrects Caster For 2 Inch To 4-1/2 Inch Of Lift. The New Upper And Lower Control Arm Mounting Holes Are Precisely Positioned To Provide The Correct Caster At The Listed Lift Heights.
• The Upper Control Arm Mount Provides Two Hole Positions For Proper Caster Settings Through The Full Lift Height Range
• The Proper Mounting Locations For The Installed Lift Heights Are Outlined In The Installation Instructions
• Improves The Front Drive Shaft CV Joint Operating Angles Through Full Wheel Travel. The New Geometry Increases Clearance Between The Front Driveshaft And Exhaust At Full Suspension Droop
• Brackets Are Made From Heavy-Duty 7GA Steel And Are Fully Boxed And Welded For Superior Strength When Compared To Bolt Together 2-Piece Designs
• The Heavy Boxed Construction, Fully Gusseted Lower Mount And Welded Crush Sleeves Give You Extra Confidence Both On And Off Road
• The Control Arm Correction Brackets Can Be Used With JKS Adjustable Control Arms For The Ultimate On And Off Road Performance
• The Brackets Install Inside The Factory Upper And Lower Control Arm Mounts With The Factory Hardware
• Limited 90 Day Warranty